Twin Screw Roller Head Extruder

Our Twin Screw Roller Head Extruder is offered in various sizes with output ranges from 500 kg/hour (1,100 lb./hr) to 20,000 kg/hr (44,000 lb./hr). This unique twin screw design requires no pushers and greatly reduces energy requirements and manpower. Non-contact twin screw design requires less maintenance. Rubber discharge temperatures can be reduced while sheeting out the material because no additional work is introduced into the compound allowing the TSR to be used under master batch and final-mix mixers. The TSR can be used in combination with a BB16-liter up to BB620 mixer.

  • Replaces traditional drop mill
  • Lower energy consumption
  • No pushers
  • Continuous discharge in sheet
  • No additional heat is added to the material
  • Low profile fits under most Intensive mixers
  • Non-contact screw tips minimize wear
  • No operator required once material is started
  • Easier clean out because of 15º incline flow
  • Reduces possibility of contamination
  • Various drive configurations

Click here for detailed information about the Twin Screw Roller Head Extruder.

Click here for the Twin Screw Roller Head Extruder sizing information.